|
| stronghold05 |
|
||
|
 I have accidently pulled the ignition lead from the spark plug connector   , can anyone point me in the right direction on how to fix this? they bosch 8mm, pub hol today( cant just get new ones), 5am start in the morning, if anyone can help or has a temp fix for this problem It would be greatly appreciated thankyou
_________________ 98 el sapphire |
||
| Top | |
||
| Lowlane7 |
|
||
|
If the metal clip has come out of the end of the lead its stuffed.
I've never bothered trying to repair them myself but someone else may have..? AFAIK they are put together with silicone lube and aren't like regular wires..
_________________ [color=#004080]Cheers, Jacob. |
||
| Top | |
||
| Falcon96XR6 |
|
|||
|
Your f***ed ahah. No offence.. but seriously, shes goin to be on 5 cylinders for a few days. Thats what happens when you pull on the lead not the plug.. lol
_________________ EL XR6, T5 Speed - Full Factory Fitted Tickford Body Kit, AU Engine, Billet Camtech 845 Cam, J3 Chip, MLS Gasket, Intake, Extractors, High flow cat, 2 1/2in exhaust, K&N Air Filter, 3.45 LSD, - My Pride and Joy |
|||
| Top | |
|||
| stronghold05 |
|
||
|
damn!
!, i was afraid of that
_________________ 98 el sapphire |
||
| Top | |
||
| Falcon96XR6 |
|
|||
|
Only thing i can suggest at this point is see if a friend or relo can lend you a lead till tomorrow.. someone you know may have a set spare from replacing them or something.. sorry mate..
_________________ EL XR6, T5 Speed - Full Factory Fitted Tickford Body Kit, AU Engine, Billet Camtech 845 Cam, J3 Chip, MLS Gasket, Intake, Extractors, High flow cat, 2 1/2in exhaust, K&N Air Filter, 3.45 LSD, - My Pride and Joy |
|||
| Top | |
|||
| Lowlane7 |
|
||
|
You should be able to putt around on 5 though.
It will just idle rougher just imagine its a lumpy as V8  lol.
_________________ [color=#004080]Cheers, Jacob. |
||
| Top | |
||
| TedW |
|
||
|
Open lead end of terminal - strip outer insulation carefully from silicon core long enough to lay back inside terminal and recrimp with pliers - (temp repair only) ...........
|
||
| Top | |
||
| Nigel |
|
||
|
^^ what he said. Or use an old lead. But the temp repair should work. Doesnt matter if its shorter, 7mm, 6mm. As long as its an ignition lead
If you *must* run around on 5 cylinders, consider disconnecting the injector so your not putting raw fuel through to your cat. your O2 sensor isnt going to be in love with how your car goes either. Nigel |
||
| Top | |
||
| stronghold05 |
|
||
|
ended up doing the temp job by cutting and rewiring,bit of electrical tape no problems at all!! thanx guys & thanx again fordmods!!
_________________ 98 el sapphire |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 2 guests |
