Fordmods Logo

 XH Snorkel
The XH Intake snorkel fitted to an Jarrod's EB 6 Cylinder

Jarrod Baker's [aka EDMONTY] Information for adding an XH Snorkel to an EA-ED MPEFI
This document describes how to add the XH series Intake snorkel to the EB, and ED 6 Cylinder Models. (MPEFI)
This information as well as snorkel fitting pictures have been kindly supplied by Jarrod Baker.
This modification costs a total of $32.00 (New Genuine Snorkel), and takes approximately 10 Minutes to fit
The Ford Part Number for the Snorkel is EHC9C675-A.

Snorkel Fitting
You will require a 3mm drill bit, and a drill to add some new snorkel mounting screws.
Please Note : The Radiator is located directly underneath the area in which the holes for the snorkel will need to be drilled.
The Utmost care must be taken when drilling this area, as to not puncture the Radiator housing.

Fitting Instructions
  • 1) Remove the Original Snorkel, by removing the 2 retaining Clips, and pulling the original snorkel mouth away from the Airbox.
  • 2) Fit the new XH snorkel to the Airbox, by simply pushing the Snorkel mouth over the Airbox.
  • Note the cutting line marked on this snorkel
  • 3) Whilst the snorkel is fitted, mark 2 holes where the snorkel mounting screws are to be placed
  • 4) Drill the 2 marked holes using the 3mm Drill bit, and taking care that you do not peirce the Radiator below.
  • 5) Use some short shank self tapping screws to affix the snorkel in place.
  •  
     Document Summary
     
    Document description: Information on fitting a the XH snorkel to an EB/ED Falcon
    Document written by: Matti on 14 2002>, Copyright © 2005 Matti, all rights reserved.
    Document revised: 12 2005 - Revision 1.0
    Document views: 16697 since 14 2002



     

     

    It is currently Fri Mar 29, 2024 7:58 am All times are UTC + 11 hours

     

     

    (c)2014 Total Web Solutions Australia - Australian Web Hosting and Domain Names