|
| -clampy- |
|
||
|
hey dudes, just wondering, has anyone put an eec 4 into a previously carb'd ford? what did you do for loom? reuse e series one? or make all new? or combination of both?
_________________ current ride: worn out chuck taylors |
||
| Top | |
||
| low_ryda |
|
|||
|
http://www.fordfuelinjection.com this may help. if not it's still pretty handy.
_________________ Not to get technical, but according to chemistry alcohol is a solution. |
|||
| Top | |
|||
| Scaffy |
|
|||
|
Good to see you're still about mate!
I'd imagine that using an e-series loom would be the way to go as everything is already there and it's just a matter of re-routing it all. You'd probably be able to neaten in up a bit though. What are you putting it into?
_________________ Trickflow Street Heat top end kit, 70mm BBK TB & EGR, 24lb injectors, Underdrives & 3.73s: 275rwhp - 13.15@105mph NA / 12.37@116mph N20 |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 17 guests |
