hi guys,
my uncle has a 95 XG panel van and his 6 is stuffed so i would like to no if the 95 ef 6cyl i have just pulled out of my fairmont will

#bolt straight up to the 4 speed column shift auto box?
#are the looms the same?
#can we use the ef inlet manifold?

i would assum it would be a straight swap but i would like to make sure before we start.

any help would be great.

block head = same
wiring = different (coil vs. coilpack)
Manifold different, unless you wire in the butterfly trigger and run an EL ecu.
Then you may hit the bonnet.

change over hte harmonic balancer etc.

Or even install thermo's and keep the serpintine belt/alternator/power sterring pump.

Replace the long motor and bolt on all the other goodies, distributor and accesories and it'll be the same as the original.

I don't think you have to replace the timing cover to use the original pulley setup.