|
| briney |
|
|||
|
has anyone on here had trouble with a relatively low km ( 80-ish k )AU motor jumping the cam timing ? the oil in it was black. is this tied up with it ?
_________________ vote for pedro ? f**k pedro, f**k him up his stupid a***hole. |
|||
| Top | |
|||
| xcabbi |
|
||
|
If the timing chain has jumped then the tensioners have most probably snapped. Does it still run at all?
|
||
| Top | |
||
| briney |
|
|||
|
i have swapped it with another low k engine. it still ran, but was crook. i reset the cam timing. it has some bent inlet valves.
_________________ vote for pedro ? f**k pedro, f**k him up his stupid a***hole. |
|||
| Top | |
|||
| briney |
|
|||
|
the question i would like answered is why ? i have seen/heard of a few au's doing the same thing. any one else heard of it and why it happens ?
_________________ vote for pedro ? f**k pedro, f**k him up his stupid a***hole. |
|||
| Top | |
|||
| Disco Frank |
|
|||
|
no idea man
my auxr65 has over 215,000kms and driven damn hard a fiar few of them never skipped a tooth at all could happen to maybe lack of routine servicing and dirt gettign into tensioner? or a weak chain?
_________________ RIP SCOTT |
|||
| Top | |
|||
| stockstandard |
|
|||
|
Its news to me as well. Definitely not a common problem (unless people stuff around with the tensioner)
_________________ Stoke me a clipper, I'll be back for Christmas |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 50 guests |
