|
| ironworker |
|
||
|
Can anybody please help me, I am having trouble with the drive belt adjustment on the ef 4.0lt 6cyl
_________________ IronWorker |
||
| Top | |
||
| Krytox |
|
|||
|
its self adjusting!
you may have to purchase a longer/smaller belt I run a 6PK2350 instead of the Listed item number..
_________________ Carefree, we may not be number one, but we're up there. |
|||
| Top | |
|||
| ironworker |
|
||
|
I realise it is self adjusting I was after info on an easier way to get it on/off than brute force levering tensioner wheel etc
_________________ IronWorker |
||
| Top | |
||
| snap0964 |
|
|||
|
The usual method is a half inch drive with ratchet, fit to the square hole, rotate whole lot clockwise - not too difficult with a trolley jack handle on the ratchet arm.
Make sure you have the correct tensioner with belt to match. Your belt should slip on reasonably easy with tension off. EF/EL and XH tensioners are similar, but not the same - an XH tensioner using an EF/EL belt is next to impossible to get on.
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| ironworker |
|
||
|
Hey Thanks Snap
I did it the hard way but I tried your way ........ Much Much easier Next time it will be easier
_________________ IronWorker |
||
| Top | |
||
| GTBob |
|
|||
|
snap0964 wrote: The usual method is a half inch drive with ratchet, fit to the square hole, rotate whole lot clockwise - not too difficult with a trolley jack handle on the ratchet arm.
Make sure you have the correct tensioner with belt to match. Your belt should slip on reasonably easy with tension off. EF/EL and XH tensioners are similar, but not the same - an XH tensioner using an EF/EL belt is next to impossible to get on. Does your's have a 1/2 " square? mine is 3/8 drive ratchet size  
_________________ Rotten Old Revhead!!! XW GTHO + EF ex cop car (exractors 2.5 cat back zorst !6" Simmons K&N +airbox mods Lowered with Bilstein shocks+Whiteline Bars NEXT THING Swap HO for GTP or Ferrari! |
|||
| Top | |
|||
| snap0964 |
|
|||
|
ironworker wrote: Hey Thanks Snap No probs dude . . . I did it the hard way but I tried your way ........ Much Much easier Next time it will be easier GTBob wrote: Does your's have a 1/2 " square? mine is 3/8 drive ratchet size Nah, I was in a hurry writing the reply. Good pickup old fella  .
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| twr7cx |
|
|||
|
Yeha I esd gunna say mine is 3/8" aswell... Lol
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: Google [Bot] and 38 guests |
