|
| MY.93.ED |
|
||
|
Hi ..have finally got all the gear to put el bbm ecu and thermo,s on my eb s1 which runs an AU engine,but I have a couple of question that I need to ask for help.I purchased with the thermo fans the original relays out of the EL wreck (4 relays in the box mount )plus a lot of the wiring from fans to relays and relays in to the wiring loom,need help in which wires go to ecu and which go to where else to get the fans working off the ECU or a diagram to work off to get them working...
_________________ Silver EB Fairmont- AU S3 engine, Tickford Head, EF handbrake, T5 manual, EF XR6 3.45 LSD, 2.5" Catback by Rapid Exhaust, EL BBM, EL XR6 ECU, EL Thermos, EB Ghia interior, Kingy Superlows, Monroe struts |
||
| Top | |
||
| alfy12 |
|
|||
|
The Technical documents section has an article describing the different thermofan wiring and the installation process. Should help with your install. I think EL thermos ran a 3 relay setup. You may have a setup out of an EF.
Heres the link. documents.php?d=54
_________________ NF Fairlane: Non Factory Dual Fuel - New coolant tank, New fuel injectors, New fuel pump, New earth cable, ECU capacitors replaced, New O2 sensor, leads and plugs, New Radiator/Condensor cleaned. 483,000kms. AU I6 Powered. Struts, Shockies, Tie rods and ball joints replaced. |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 52 guests |
