|
| imtroidz |
|
||
|
Does anyone know what the torque settings are for a ford el exhaust manifold. I have looked in my owners manual and a gregorys manual, they both say tighten the bolts to the specified torque
 specified where.I know most of us just tighten them by hand but i want to get it right this time. Dont want another exhaust leak 
|
||
| Top | |
||
| phongus |
|
|||
|
imtroidz wrote: Does anyone know what the torque settings are for a ford el exhaust manifold. I have looked in my owners manual and a gregorys manual, they both say tighten the bolts to the specified torque specified where.I know most of us just tighten them by hand but i want to get it right this time. Dont want another exhaust leak should be in the Gregory's manual at the start of the chapter. 27Nm....on page 23 of the Gregory's manual
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| imtroidz |
|
||
|
phongus wrote: imtroidz wrote: Does anyone know what the torque settings are for a ford el exhaust manifold. I have looked in my owners manual and a gregorys manual, they both say tighten the bolts to the specified torque specified where.I know most of us just tighten them by hand but i want to get it right this time. Dont want another exhaust leak should be in the Gregory's manual at the start of the chapter. 27Nm....on page 23 of the Gregory's manual Hmmm doesnt feel very tight, could just be this huge torque wrench im using. thanks anyway phongus |
||
| Top | |
||
| XRfairmont67 |
|
|||
|
remember u are tightening a bolt into alloy, can strip them easy enough if u go too tight
|
|||
| Top | |
|||
| phongus |
|
|||
|
XRfairmont67 wrote: remember u are tightening a bolt into alloy, can strip them easy enough if u go too tight +1 no problem imtroidz...but as XRfairmont67 said, you're screwing into an alloy head...they are softer than iron blocks. Also yes, if you are using a long a** torque wrench, it will feel very soft 
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 75 guests |
