|
| Lynx_E's |
|
||
|
Hey guys,
i have smoke coming out of the conecter that runs from the positive terminal down to a conecter, it has a green and a purple'ish wire going into it an 2 yellows coming out. the smoke comes from this connecter. i swapped the 2 wires coming from the battery, but its the connecter with the 2 yellows causeing the problem. can i cut another one of my spare car and crimp it on? thnx lynx
_________________ 1989 Fairmont Ghia
|
||
| Top | |
||
| smiley235 |
|
|||
|
hey mate, I think I could help ya with this 1, just gotta give a bit more of a detailed imaged so we can understand what you mean.
Positive terminal of what? What is this connector for or where is it located? If its smoking, theres a short circuit in there, have a look and make sure a wire hasn't come loose or bared itself.
_________________ 178.3 rwkw
|
|||
| Top | |
|||
| MRE-50L |
|
|||
|
have you installed any radio gear or driving lights to the car ?
_________________ Chance Favors The Prepared Mind ! |
|||
| Top | |
|||
| Lynx_E's |
|
||
|
of the positive terminal on the battery, there is a main thick red lead, then a small plate with some other wires running of it. these wires all disapper done past the drivers side wheel arch into the main loom. ill have pics tomorrow
_________________ 1989 Fairmont Ghia
|
||
| Top | |
||
| smiley235 |
|
|||
|
No worries, until the pics are up, be very wary, I just had a mate whos bonnet caught fire due to an electrical problem.
I posted it on here but no one helped (I think cause its a holden  )
_________________ 178.3 rwkw
|
|||
| Top | |
|||
| stockstandard |
|
|||
|
1st disconnect the battery if you haven't already.
Sounds like you have blown the fusible links. You need to find out why they blew, fix the problem, then get new fusible links.
_________________ Stoke me a clipper, I'll be back for Christmas |
|||
| Top | |
|||
| Lynx_E's |
|
||
|
its not a fuseable link, just a normal 2 pin connecter. its shorting somewhere on the female part.
_________________ 1989 Fairmont Ghia
|
||
| Top | |
||
| twase |
|
|||
|
If it is just a connector and it is smoking then it is heating up due to poor conectivity at the connector. Replace it by splicing in a new one and all should be good.. Leave it like this and as per a previous post it can catch fire.
_________________ BF Fairmont Ghia Series II update. |
|||
| Top | |
|||
| Lynx_E's |
|
||
|
ok my bad, it is a fuseable link, its written on both the red and green wire running down into the connecter, i just tried putting on a new one, and it just smoked up again,
rough diagram red ----> yellow Green ---> yellow/brown couldnt up load pics, but both the red and green come off the positive terminal on the battery edit ok managed to get some pics, also noted that 5 injecters have 851 on them, and the one i changed has 070 on it, is this something that would cause the problem, as it looks like those yellow wires control power to injeters and fuel pump Terminal Wires http://i133.photobucket.com/albums/q70/ ... G_0001.jpg Normal Injecter 851 http://i133.photobucket.com/albums/q70/ ... G_0002.jpg Other Injecter 070 http://i133.photobucket.com/albums/q70/ ... G_0001.jpg
_________________ 1989 Fairmont Ghia
|
||
| Top | |
||
| EL__Fairmont |
|
|||
|
The green fuseable link feeds 12v to the fuel pump relay then onto the fuel pump and the red one feeds 12v to the ECU relay which also gets power to the injectors.
start unplugging the fuel pump relay first to rule that circuit out. It's the green relay under the coolant tank. Also did you just put a new injector in and it started smoking? If that is the case then the injector you put in is drawing a s**t load of current and it should be removed.
_________________ 97 EL Fairmont 4l OHC .Silver. |
|||
| Top | |
|||
| Lynx_E's |
|
||
|
ummmmm..... i found the prob. the bolt behind the 851 plug had pinched the edge of the lead for that injecter and was earthing thru the manifold, so all the injecters are fine, including number 2
the problem is in the loom , cause the new injecter still wont fire
_________________ 1989 Fairmont Ghia
|
||
| Top | |
||
| Lynx_E's |
|
||
|
ok ive swappe dthe loom, injecters, fuel rail, presure rg, and ecu and #2 injecter still wont fire. anyone ha this problem before
_________________ 1989 Fairmont Ghia
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 61 guests |
