|
| gogetta |
|
|||
|
car (EL) sometimes wont start (wont crank)...smartlock jewel flashes code 4 :
"Electronic lock a** to BCM connector open, Electronic lock a** I/O circuit open, Electronic lock a** power supply circuit open." its not the usual dry solder BEM as i tryed that... is it likely an internal BEM fault, a wiring/connector fault or a barrel fault? anyone seen it before?
_________________ |
|||
| Top | |
|||
| Mitch_ |
|
|||
Posts: 6168 Joined: 5th Nov 2004 |
hit where the BCM is and see what it does?
_________________
|
|||
| Top | |
|||
| gogetta |
|
|||
|
Mitch_ wrote: hit where the BCM is and see what it does? yeah thats what i meant by dry solder joint...thats what the cause is...in this case that didnt help..
_________________ |
|||
| Top | |
|||
| snap0964 |
|
|||
|
gogetta wrote: its not the usual dry solder BEM as i tryed that... Could be any of those - I'd swap the BEM as an initial thing. I'm assuming you're running a low/mid series unit, so should be easy to get a spare for nix. And you can check the loom from the side of the barrel (smartlock is the small 4 pin plug) down the column to the BEM.
is it likely an internal BEM fault, a wiring/connector fault or a barrel fault?
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| gogetta |
|
|||
|
yeah its an EL fairmont so high series...I dont have a spare here...
searched through the forum threads and its come up but no-one has posted the solution once they sorted it..
_________________ |
|||
| Top | |
|||
| Greenmachine |
|
||
|
gogetta wrote: yeah its an EL fairmont so high series...I dont have a spare here... searched through the forum threads and its come up but no-one has posted the solution once they sorted it.. Yes.... there's a lot of that 
_________________ Sold the Greenmachine - now driving 2015 Jeep Cherokee Trailhawk. |
||
| Top | |
||
| gogetta |
|
|||
|
YEP
so far, as far as I know, the car is now behaving itself...all I did was wiggle the BEM connectors and cleaned the plug on the inhibitor switch...will keep this thread posted if prob returns
_________________ |
|||
| Top | |
|||
| gogetta |
|
|||
|
prob has returned...tried a known good bem...still not fixed, car is playing up more regularly now..
gunna try a known good barrel next..
_________________ |
|||
| Top | |
|||
| gogetta |
|
|||
|
fitted new barrel today...
car has been good so far...
_________________ |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 39 guests |
