|
| tonnerxh |
|
||
|
Can any one help get some extra poke out of my1tonner(xh)Iknow the diff is gunna be a problem but it's usally got heavy loads me beeing a stonemason.Just sum pull off the lights would bee good.dunnydore eating pull
|
||
| Top | |
||
| naughtyfalcon |
|
|||
|
have you done anything to it yet,like extractors,2.25 inch exhaust ?
_________________
|
|||
| Top | |
|||
| Sharpyelghia |
|
|||
|
Good quality extractors (pacemakers etc) will provide a noticable improvement in mid range torque.
I just fit a set and you can really feel the difference from 1800-3000. If the engine is in good nick you might consider a flash tune that is more focused on low-mid range torque. There's a few kw in changing the inlet piping/air filter as well.
_________________ He was like a god walking amongst mere mortals. He had a voice that could
|
|||
| Top | |
|||
| knowsfords |
|
||
|
Find a XH XR6 ECU and put a bbm on it and thena a BA airbox, intake pipe and cold air snorkel to suit.
|
||
| Top | |
||
| snap0964 |
|
|||
|
http://www.fordmods.com/forums/viewtopic.php?t=68435
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| tonnerxh |
|
||
|
naughtyfalcon wrote: have you done anything to it yet,like extractors,2.25 inch exhaust ? nar havent done any thing yet was expecting to spend heaps but just got some good ideas thanks tonner
|
||
| Top | |
||
| tonnerxh |
|
||
|
naughtyfalcon wrote: have you done anything to it yet,like extractors,2.25 inch exhaust ? nar havent done any thing yet was expecting to spend heaps but just got some good ideas thanks tonner
|
||
| Top | |
||
| tonnerxh |
|
||
|
naughtyfalcon wrote: have you done anything to it yet,like extractors,2.25 inch exhaust ? nar havent done any thing yet was expecting to spend heaps but just got some good ideas thanks tonner
|
||
| Top | |
||
| tonnerxh |
|
||
|
naughtyfalcon wrote: have you done anything to it yet,like extractors,2.25 inch exhaust ? nar havent done any thing yet was expecting to spend heaps but just got some good ideas thanks tonner
|
||
| Top | |
||
| tonnerxh |
|
||
|
naughtyfalcon wrote: have you done anything to it yet,like extractors,2.25 inch exhaust ? nar havent done any thing yet was expecting to spend heaps but just got some good ideas thanks tonner
|
||
| Top | |
||
| effalcongli |
|
||
|
yeh first get a set of extractors and 2.5 cat back system, and hi-flow cat
then have a look at pod filter and 3 inch mandrel bent air intake piping(more for if you went BBM manifold) then u be looking at bbm and ecu to suit... then after that u be looking at a cam and tune but basically you should notice a bit better torque and take off at lights from the full exhaust system and pod filter...
_________________ Pacey 4499 and 2.5 exhaust single muffler |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 53 guests |
