|
| benjameshawkins |
|
||
|
Hi Guys
My car is dead 
I have a EL gli Swapped the dash loom with a NL loom Done the climate control conv Replaced BEM - now wont start - just beeps at me 5 times - whilst the smartlock light flashes rapidly - when i try and start it I dont know if its programming the key in or not Ive programmed the Keypad in - that works But i leave the key in on the ON position for an hour - come back the smartlock light is on constant - not flashing - but it wont start just a click from where the relays are. Ive swapped the BEM - still same prob Was working fine before replacing the loom Any suggestions? |
||
| Top | |
||
| shannonwulff |
|
|||
|
is it in park? try shorting out the starter in and out wires on the bem and see if it cranks........
_________________ When you do things right, people won't be sure you've done anything at all. |
|||
| Top | |
|||
| MRE-50L |
|
|||
|
http://www.fordmods.com/forums/documents.php?doc=49
have a little read ben , took a few goes to get the bem to reprogram to the ignition barrel once
_________________ Chance Favors The Prepared Mind ! |
|||
| Top | |
|||
| benjameshawkins |
|
||
|
Yep its in park
From what the document says it isnt programming succesfully by the solid lite smartlock light - but it says i should still be able to start it So a) why is the programming unsucessful> and b) it says i should be able to start it - but i cant? |
||
| Top | |
||
| Krytox |
|
|||
|
Don't tell me ur battery's flat, I recall ur hazards were staying on, slap it on charge whilst waiting the hour and see what it does.
_________________ Carefree, we may not be number one, but we're up there. |
|||
| Top | |
|||
| benjameshawkins |
|
||
|
Yeha i had it on charge for the couple hours i was waiting for it to program
Took it out put on charge for couple hours this morning Now gonna leave overnite charging |
||
| Top | |
||
| EALCON 3.9 |
|
||
|
you said you had your battery charging while you were waiting for it to program.
does that mean it was all connected up with the ignition on and battery charging? I may be wrong and would like to be corrected if i am but doesnt charging the battery while it is still in the car connected and ignition on fry things??? i was always under the assumption that it would fry the computer and blow fuses. |
||
| Top | |
||
| Krytox |
|
|||
|
should be right,
You'll get AC ripple that can interfere with some circuits, However the battery would act as a nice big capacitor and smoothen things out, Essentially Yes, you should disconnect the terminal whilst charging, but who does.
_________________ Carefree, we may not be number one, but we're up there. |
|||
| Top | |
|||
| benjameshawkins |
|
||
|
Krytox wrote: should be right,
You'll get AC ripple that can interfere with some circuits, However the battery would act as a nice big capacitor and smoothen things out, Essentially Yes, you should disconnect the terminal whilst charging, but who does. Agreed |
||
| Top | |
||
| snap0964 |
|
|||
|
benjameshawkins wrote: just beeps at me 5 times - whilst the smartlock light flashes rapidly - when i try and start it. Was working fine before replacing the loom
So what happens when you turn IGN on ?? Does the light flash 5 times in 2 sets, then stays on or then flashes very quickly ???
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| benjameshawkins |
|
||
|
OK,
Battery is fine Got an error code now Turn the ignition onto ON Smartlock flashes 4 x - then gap 4 x gap 4 x gap - then rapidly Anyone know what this means? |
||
| Top | |
||
| benjameshawkins |
|
||
|
Yah its fixed
Dont know how - dont care either - yah |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 72 guests |
