|
| polzin |
|
||
|
Is it easy to pull the i6 out with removing the intake manifold i know i got to undo the tail shaft and a few wires i want to try and pull the engine out with the gearbox any ideas on the subject? its coming out of a s3 au
_________________ 2001 au3 ford falcon |
||
| Top | |
||
| gusbus |
|
||
|
yes u can keep the manifold on just dont let it hit the sides andits pretty easy to pull out with the transmission just make sure it tilts so it doesnt hit anything...and theres lots of things that need to be undo puled off before it comes out.. heater hoses, wires, throttle cable etc
|
||
| Top | |
||
| polzin |
|
||
|
Yep got all the over things covered cheers mate
_________________ 2001 au3 ford falcon |
||
| Top | |
||
| Disco Frank |
|
|||
|
pull the rad out as well
will give u more room  dont forget to unbolt the shifter!
_________________ RIP SCOTT |
|||
| Top | |
|||
| Troy |
|
||
|
you'll want the car up pretty high to. it's pretty simple
|
||
| Top | |
||
| arm79 |
|
|||
|
And put a bung in the back of the trans output shaft.
Could get very very very messy otherwise. |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 39 guests |
