|
| Feral |
|
||
|
Hey all,
Just replaced the cammshaft pulley on my daughter's EL and took it for a test run after a warm up. Ran OK but when I pushed my f  oot down it shuddered until it changed gear. Any ideas? Could it be low transmission fluid? or something more nasty.Thanks all
_________________ A dog, a bike, a Ute |
||
| Top | |
||
| Benny D |
|
|||
|
timing out.
or box is giving up
_________________ BA XT V8. Ice Mint. 18" Speedys. XR6T LSD. Full Pacemaker twin 2 1/2inch Stainless Steel system. Custom CAI. Black XR interior with white trimming. Powerbond underdrive kit 25%. |
|||
| Top | |
|||
| Esteven8 |
|
|||
|
Is it only doing it in a certain rev range? I had a similar issue with my EF a while ago at about 2,500 - 3,000 rpm, thought the trans was playing up as she'd shudder and f@rt about changing gears under mild acceleration. Turned out the coil pack was dieing. Replaced it and the leads and she's been fine ever since.
But being that the EL's had a dizzy ignition, check the timing is spot on before doing anything drastic. Then I'd check the condition of the coil and leads and work up from there. Hope this helps.
_________________ dc_todd wrote: Cheap pads squeal like cheap hookers, and you can take that to the bank. Au Fairmont Ghia My (Old) 95 EF Wagon |
|||
| Top | |
|||
| Gab1 |
|
|||
|
running on 5 cylinders
|
|||
| Top | |
|||
| Feral |
|
||
|
Mmmmmmmmmmmmm,
OK, can replacing the pulley put the timing out?
_________________ A dog, a bike, a Ute |
||
| Top | |
||
| phongus |
|
|||
|
Feral wrote: Mmmmmmmmmmmmm, OK, can replacing the pulley put the timing out? By pulley, did you mean the camshaft gear? If so yes...one tooth out can have an effect. If you meant crank pulley...or harmonic balancer, most likely no.
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| slammeb |
|
||
|
Change the plugs, simple.
|
||
| Top | |
||
| wild-el |
|
||
|
i changed my motor in my el and dropped a au motor in got the car back on saturday it was running like a pig under 2500rpm and shuttered at around 1500rpm, took it to one of my dads old mates and recently recomended by phongus at northeren motor works in somerton today spent 30bucks,turns out it was 30 degress out and so he timed it propperly and bluddy thing flys now.im more then happy with my decision
_________________ EL xr6,standard a** au motor,hi-tech headers, 2 1/2inch red back,,Tikky kitted and wingless,Black GT-P's,on ultra lows and still too high |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: Facebook [Bot] and 75 guests |
