|
| Ugly Igley |
|
|||
|
I have noticed lately that when i start the EF on a cold day i get a grind noise for the enginebay.
Now as it seems it is the initial start after the engine has had time to completely cool down, otherwise starts like normal if even slighty warm. Any ideas would be appreciated.
_________________ Proud owner of one of very few BF SR manual (June 06 build) |
|||
| Top | |
|||
| Slick |
|
|||
|
Ugly Igley wrote: I have noticed lately that when i start the EF on a cold day i get a grind noise for the enginebay. water pump bearings I suspect.
Now as it seems it is the initial start after the engine has had time to completely cool down, otherwise starts like normal if even slighty warm. Any ideas would be appreciated.
_________________ Mind f**k!!! it works on feeble minded ignorant sheeples... there's plenty of em on this site... some are very intelligent but by god they are so thick!!! Pakrat wrote: You can buy them seppertly
|
|||
| Top | |
|||
| TIKFORD |
|
||
|
starter motor drive
|
||
| Top | |
||
| Smackdown |
|
|||
|
I was leaning towards the starter motor staying engaged for that little while after the cylinders start firing. Pull it out, grease it up, put it back.
_________________ BA Falcon Futura on EGas. Stock as...
|
|||
| Top | |
|||
| drazull |
|
||
|
I have noticed a similar problem.
Never given any greif.
_________________ Not lost any demerit points |
||
| Top | |
||
| Slick |
|
|||
|
heres how you trace and eliminate one from the other, spray the water pump pulley with WD40 when you start her up first thing in the morning.
If the grinding noise disappear while engine is running then its the bearing, might be a pit of free play. if not, it could be the starter motor as suggested.
_________________ Mind f**k!!! it works on feeble minded ignorant sheeples... there's plenty of em on this site... some are very intelligent but by god they are so thick!!! Pakrat wrote: You can buy them seppertly
|
|||
| Top | |
|||
| Steady ED |
|
|||
|
Starter Motor I'd say.
Mine was doing the same thing, so I took it to the autosparky and just got a reco put in. Upon further inspection of the f**k one, it was just that. f**k. The effect of not disengaging from the flywheel quick enough meant there were chunks of gear tooth floating around inside it...
_________________ ED XR8 Sprint - S-Trim, V500, 249rwkw |
|||
| Top | |
|||
| Ugly Igley |
|
|||
|
Sweet thanks for the help guys.
Looks like something has gotta be replaced either way. Trusting my luck it will be both.
_________________ Proud owner of one of very few BF SR manual (June 06 build) |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: Google Adsense [Bot] and 71 guests |
