Fordmods Logo

Vernier Cam Gear 

 

Page 2 of 2 [ 17 posts ] Go to page Previous  1, 2

 
Posted: Tue Mar 14, 2006 4:57 pm 
Parts Gopher
Offline

Posts: 56

Joined: 16th Sep 2005

Location: sydney
NSW, Australia

If you have the head off you can get some plastacine or blu tac and place it on the top off the piston, do a trail assembly and slowly rotate the engine by hand 720 deg. the valves wil contact blu tac nd you can then measure the clearance to the top of your piston. This method works very well and you can see the result. If while you are rotating the engine it starts top lock up stop and check the clearance. Just remember do it slowly and by hand.
Good luck
steve
Top
 Profile  
 
 
Posted: Tue Mar 14, 2006 10:03 pm 
Getting Side Ways
Offline
User avatar

Age: 34

Posts: 4305

Joined: 6th Jul 2005

Ride: BA xr8 Magnet ute

Location: Melbourne
VIC, Australia

nah shes all good now, turns out we were following instructions for a earlier modle set up (f**k CROW!!) basicly we just slapped her on and did a trial and error adjustment by 2 degrees each time.
Top
 Profile  
 
Display posts from previous:
Sort by  
 Page 2 of 2  [ 17 posts ]  Go to page Previous  1, 2

Who is online

Users browsing this forum: No registered users and 74 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

 

 

It is currently Fri Mar 29, 2024 5:54 pm All times are UTC + 11 hours

 

 

(c)2014 Total Web Solutions Australia - Australian Web Hosting and Domain Names