What are these, and are they needed in the au to el conversion?
also i want to use the au knock sensor plugs, i want to graft the connection into the el harness. the colours of the wires i have on the el harness are 1x solid blue and 1x blue with yellow lines on and the au harness plug is 1x yellow and 1x yellow with red lines.
i also need to know where the bosch ignition coil for the dizzy bolts to.

thanks.

The round sensor is the Cam Sensor and the other is the crank angle sensor. They are not needed if using a Dizzy. You can remove the Crank angle sensor if you wiish. If you pull the cam sensor there will be a hole in the timing case.

As for the knock sensor I am not sure of the wiring.

For the coil, mount it where you want to. The one on the Wagon is mounted off the AC Compressor with the wiring extended to suit, makes it easier to change at a later date.

ah cool i'll just make it look like they're plugged in then.
ignition coil will be fun then

Pull the Crank angle sensor, 2 small bolts and cut the cable to the cam sensor. job done.