Fordmods Logo

where to go from here? 


Page 2 of 2 [ 16 posts ] Go to page Previous  1, 2

 Post subject: Re: where to go from here?
Posted: Tue Jun 14, 2011 11:41 pm 
Getting Side Ways

Age: 66

Posts: 2548

Joined: 18th Mar 2006

Ride: EF-XR8chaser

Location: wollongong
NSW, Australia

No doubt there is a method to check how well your valves seal, but I don't know how... when the valve seats are cut,lapped ,the valves are vacuum checked,if ok its assembled.did you bend a valve in 6 cyl. on assembly?as was said how much shiming was used,did you check valve springs and seat pressures.if the heads ok,then head gasket or rngs-worn or broken.timing.




Display posts from previous:
Sort by  
 Page 2 of 2  [ 16 posts ]  Go to page Previous  1, 2

Who is online

Users browsing this forum: No registered users and 23 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum



It is currently Mon May 21, 2018 11:07 am All times are UTC + 11 hours



(c)2014 Total Web Solutions Australia - Australian Web Hosting and Domain Names