|
| eb_guy888 |
|
||
|
what type of glue have people found works best putting carpet and material on wood?
|
||
| Top | |
||
| au man |
|
|||
|
I have just used liquid nails, had some left over
|
|||
| Top | |
|||
| eb_guy888 |
|
||
|
and it stuck fine?
|
||
| Top | |
||
| au man |
|
|||
|
yer i hope i dont have the sub box any more, i used it for like 3 months.
|
|||
| Top | |
|||
| phongus |
|
|||
|
I used any glue I had in my garage...I think i ended up using a tube of silicon glue for glass and shower areas when I did my rear parcel shelf and stuck down pretty good...can't take it off without ripping the carpet
phong =P~
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| cooki_monsta |
|
|||
|
use carpet tack nails...
_________________ Mods: sprint kit, steeda short shift, svo lip, El handles, El Air intake, au xr wheels, lukey cat back, jbl focal and pioneer sterio <--- Sold |
|||
| Top | |
|||
| TickXR |
|
|||
|
Motor trimmers and car audio installers use a BRUSH CONTACT TRIM CEMENT
It's a contact adhesive that bonds to itself Best way to apply it is by using a spray gun, you first spray the underside of the fabric you wish to use then also spray the surface you wish to apply the fabric to Wait couple minutes for glue to tac off then apply the fabric to the surface you wish to cover CAUTION: This is VERY strong cement so try to get it right the first time as once the 2 glued surfaces come into contact with each other it takes quite a bit of effort to remove and try again Usually if you have to take off and try again you will need to give them a light spray again so it will bond
_________________ If you don't do it whilst your livin, you aint got no bloody chance when your dead!!! |
|||
| Top | |
|||
| twr7cx |
|
|||
|
Loctite Contact Adhesive.
|
|||
| Top | |
|||
| Bsjenko |
|
|||
|
Just use sticky tape.
_________________ The Lane Lives.... Finally!!!! |
|||
| Top | |
|||
| eb_guy888 |
|
||
|
trust u to come up with an answer like that Ben
|
||
| Top | |
||
| TwinturboBMX |
|
|||
|
When i did a parcel shelf in a car i just used some spray on glue, worked a charm, spray the wood, then spray the fabric and apply. And yeah make sure it is done right the first time.
Oh and the parcel shelf is still going strong, was a custom made parcel shelf for a VW golf, looked good until the felt fabric faded due to sun damage.
_________________ 17" Tezza Steelies, King F**king lows, pedders sports ryders, 2.5" cat back exhaust, pacemaker extractors, T5 manual
|
|||
| Top | |
|||
| phongus |
|
|||
|
TwinturboBMX wrote: When i did a parcel shelf in a car i just used some spray on glue, worked a charm, spray the wood, then spray the fabric and apply. And yeah make sure it is done right the first time.
Oh and the parcel shelf is still going strong, was a custom made parcel shelf for a VW golf, looked good until the felt fabric faded due to sun damage. should have just used normal fabric  lasts longer.
Well my silicon glue is still holding on tight...and nothing wrong so far even though its been outside since may and sun shining on it every now and then. phong =P~
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| TwinturboBMX |
|
|||
|
phongus wrote: should have just used normal fabric lasts longer.phong =P~ I really didnt give a s**t as it wasnt for my car, it was for my sisters. And she went out and bought the material.
_________________ 17" Tezza Steelies, King F**king lows, pedders sports ryders, 2.5" cat back exhaust, pacemaker extractors, T5 manual
|
|||
| Top | |
|||
| phongus |
|
|||
|
TwinturboBMX wrote: phongus wrote: should have just used normal fabric lasts longer.phong =P~ I really didnt give a s**t as it wasnt for my car, it was for my sisters. And she went out and bought the material. ahhh....women LOL
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| tdog |
|
||
|
contact adhesive, spray or brush
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 9 guests |
