|
| TURBO_GHIA |
|
|||
|
here is mine hopefully gonna finish it this month
_________________ HMMMM BOOST !!!
|
|||
| Top | |
|||
| raabz |
|
|||
|
Man, that's a big a** box. Kinda why I changed to the setup you see above (Thanks MRE40L for the idea
 ) I'd bet it goes harder than mine does now, but at least The boot space is saved.
Ya reckon I could get two 15's behind my seat?
|
|||
| Top | |
|||
| Daniel |
|
|||
|
raabz wrote: Man, that's a big a** box. Kinda why I changed to the setup you see above (Thanks MRE40L for the idea
) I'd bet it goes harder than mine does now, but at least The boot space is saved. Ya reckon I could get two 15's behind my seat? Yes, if you really wanted! 
Seen it before, JUST fits, dunno what type of sound it'd produce however.
_________________ BF Typhoon, Dejavu - 6sp Auto, Leather, Sunroof, 19"s, Electric Pedals, Tint, FPV Sports Wheel, FPV Mats. |
|||
| Top | |
|||
| raabz |
|
|||
|
Nah - I'm not that keen. Although, As my board in the car only cost $14, I'm keen to try the two 8's either side of my 12 ,if the undershelf pod idea doesn't work out. But.....If I can get a good enough monoblock brought back from USA in september..... I'm talking around 2000wrms, I might think about something more!
|
|||
| Top | |
|||
| mickysacca |
|
|||
|
hey raabz, how did u get the MDF sheet to fit over the rear shock towers???ive had a look at mine and there might be maybe 5-6mm between the rear of the seat and edge of the tower...
|
|||
| Top | |
|||
| MRE-50L |
|
|||
|
a sheet of 12mm will fit
all u need to do is loosen the striker pins for the rear seat latches to all the way forward i have done that and it works
_________________ Chance Favors The Prepared Mind ! |
|||
| Top | |
|||
| raabz |
|
|||
|
I used 16mm. I wish I used 12mm, but I still might go back and change it. I totally removed the two covers. The board is 1180mmx450mm. You should be able to buy a 1200mmx450mm board, therefore only one cut.
I also cut a line across the front of the parcel shelf where the carpet comes down and removed the carpet. This added about 2mm more space. If you do what MRE40L said (which I haven't yet) you should still be able to latch your seats closed. Mind you, if you do my install, you must have your box totally seal (mine isn't yet) and tune it properly, otherwise certain songs will sounds like crap. |
|||
| Top | |
|||
| MRE-50L |
|
||||||
|
nearlly done
_________________ Chance Favors The Prepared Mind ! |
||||||
| Top | |
||||||
| sickd |
|
|||
|
MRE-40L wrote: nearlly done
are the subs in a box or have you sealed the area betwwen the seats and the the board were your subs are?
_________________ BA XR8 BOSS 260
|
|||
| Top | |
|||
| MRE-50L |
|
|||
|
subs are in a seal'd box
_________________ Chance Favors The Prepared Mind ! |
|||
| Top | |
|||
| sickd |
|
|||
|
ebturb wrote: here is what my boot looks like
same question as above did you seal the area between your rear seat and subs if so is the floor of the sealed are and the top , timber or you didnt bother
_________________ BA XR8 BOSS 260
|
|||
| Top | |
|||
| Rmyers |
|
|||
|
Waggin wrote: Your sub is a Punch HX2 isnt it ?
It's a power HX2, not punch 
|
|||
| Top | |
|||
| raabz |
|
|||
|
MRE-40L - that's looking pretty sweet! Congrats on a great install. I'm going back to put in a 12mm board in between my seats soon.
What else have you got to finish on it? |
|||
| Top | |
|||
| MRE-50L |
|
|||
|
right hand amp surround and remodel under the floor for wheel brace and jack handle , slim jims n other stuff
_________________ Chance Favors The Prepared Mind ! |
|||
| Top | |
|||
| TURBO_GHIA |
|
|||
|
where did ya get ya carpet from?
_________________ HMMMM BOOST !!!
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 21 guests |
