|
| nato83 |
|
||
|
Hey guys, does anyone know if its a simple procedure to put the clear AU Side Indicators into an EF. I was unable to find anything in the Tech Documents on it. Any help would be appreciated. Obviously i wouldnt be keeping the rubber door mould on the car still.
|
||
| Top | |
||
| EFNA |
|
|||
|
ive seen them on GLIs before so i think there simple swap over, just neede orange bulbs
_________________ AU FAIRMONT GHIA: 5.0 Dealer ordered SVO mods ( seeking clarification ATM), tickford suspension. |
|||
| Top | |
|||
| nato83 |
|
||
|
Thanks mate, I will hopefully pick up a set tomorrow and have a crack at the install.
|
||
| Top | |
||
| thepistonhead |
|
|||
|
They're a completely different size mate!
You would need to patch up your existing indicator hole and then drill a hole in the guard and divert your wiring. Not worth the trouble IMO, go for the NF/L clear indicators.
_________________
|
|||
| Top | |
|||
| nato83 |
|
||
|
thepistonhead wrote: They're a completely different size mate! You would need to patch up your existing indicator hole and then drill a hole in the guard and divert your wiring. Not worth the trouble IMO, go for the NF/L clear indicators. Thanks for the info, i went down to a wreckers today and pulled one out of an au and tried to slide it into an ef and the au one just slid around- i considered using some sikaflex but the nf/nl will be a neater option. Thanks again |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 12 guests |
