|
| j-mac |
|
||
|
Wondering if anyone has or would know the cost of putting a BA type front onto a AU xr6... Any advice on who could be of assistance would be appreciated.
J-Mac |
||
| Top | |
||
| Soulfire |
|
|||
|
hmm.
Completely different front shape, different bonnet angle etc. Sounds like it could be a pain in the a***. Plenty of places do strawberry conversions (s15 silvia front end on earlier models / 180sxes) so I'd assume you'd need to speak to a panel shop that does this sort of stuff. |
|||
| Top | |
|||
| wicksy |
|
|||
|
it is possible glenn knows exactly,pretty sure u need front guards,bonnet radiator support and all that s**t, is it possible
_________________ Now i have a EF XR8 5spd.........mmmmmm 5L |
|||
| Top | |
|||
| justfordima |
|
|||
|
Im assuming the AU and BA shells are very similar?
In that case it would be just like converting an EB/ED front into an EF/EL.. Which has been done also. You need quarters, front bar, headlights, indicators, bonnet, radiator support and little bits and pieces. Cheers
_________________ ;++JustForDimSim++;
|
|||
| Top | |
|||
| cheersdude |
|
|||
|
It's been done before, they say it's a prick of a job..
The doc & botch on Ford Forum's have done it..
_________________
|
|||
| Top | |
|||
| GlennBA |
|
|||
|
Check out aff, the dok did it to a smashed AU fairmont wagon, and another guy did it to an AU ute that had an engine fire and needed a new front. On an AU XR sedan though.. the front wouldn't match the rear.. it'd look a bit silly.
|
|||
| Top | |
|||
| Rapier |
|
||
|
GlennAUII wrote: Check out aff, the dok did it to a smashed AU fairmont wagon, and another guy did it to an AU ute that had an engine fire and needed a new front. On an AU XR sedan though.. the front wouldn't match the rear.. it'd look a bit silly.
yeah i saw that car at the adelaide all ford day looked damn good to the wagon that is |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 24 guests |
