g'day all
got myself a little bit of a problem.I cant seem to get a consistent door gap from top to bottom on my back right door.

i cant seem to get the attachment working but the gap starts normal, then as it goes round the wheel arch its super close, then it opens up again.

any ideas

cheers all

simo

How are the vertical gaps? Do the crease lines through the door match up front and back? If its correct height wise, then theres a chance that theres been damage in that area and its been repaired wrong. Otherwise, if the door has dropped at the rear it would make it look close in that area i think

cheers
all heights are fine,
its as if the wheel arch is slightly out of round but its definitly not visible, there are no ripples/dints or iffy looking areas around??