|
| au man |
|
|||
|
Hey all, just a question i have always wanted to have driving light in my AU but there is no room. I have looked at puting a TE50 kit on but just want the front bar and it would look out of place. So does anyone know if a BA/BF front bar would fit?
Thanks |
|||
| Top | |
|||
| GlennBA |
|
|||
|
ba/bf front won't fit an AU. Canberra car styling do a kit for au's which is less bulky than the T3 kit. That might look ok if you get the front bar off them. I'm pretty sure it'll hold driving lights.
|
|||
| Top | |
|||
| MilleniumFalcon |
|
|||
|
Get a nice big round hole cutter attachment for your drill and any front bar will hold driving lights
I have seen a few AU's that mount the driving lights (small oval ones) in the mouth of the front bumper. |
|||
| Top | |
|||
| Mechan1k |
|
||
|
I have fog lights and driving lights on my AU ute.
No aftermarket front bar .... there is a nudgebar though. I fitted my foglights just under my numberplate in that small section at the bottom. I'll chuck up a coupe of rough photos. 
_________________ 04 Territory TX AWD - Winter White - optioned up |
||
| Top | |
||
| au man |
|
|||
|
Ok thanks for that they look good might do that. Does anyone know why wont the front bar fit?
|
|||
| Top | |
|||
| MilleniumFalcon |
|
|||
|
If you know the right people you can get any bar modded to fit
 .
There's an AU on the forum with BA XR bumpers, do a search, the interior was converted to a BA as well. |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 24 guests |
