|
| kbromage |
|
||
|
hi peoples,I have no heater in my na fairlane. i have run a full diagnostics, read all of your forums on the subject.blend servo is working[according to the computer] all vac hoses are working,switches etc i'ts driving me nuts.not to mention my mechanic.Any more ideas?apart from sending me some matches.
|
||
| Top | |
||
| raiki |
|
|||
|
Is the hot water tap working ????
Perhaps your heater unit is blocked. Diconnect the hoses under the hood and flush it out.
_________________ Adrian
|
|||
| Top | |
|||
| kbromage |
|
||
|
kbromage wrote: hi peoples,I have no heater in my na fairlane. i have run a full diagnostics, read all of your forums on the subject.blend servo is working[according to the computer] all vac hoses are working,switches etc i'ts driving me nuts.not to mention my mechanic.Any more ideas?apart from sending me some matches. I flushed the system the core' s not blocked.heater valve operates ,normal running engine temp.question?would the coolant temp sensor have anything to do with the heater operation?
|
||
| Top | |
||
| joolz |
|
|||
|
are the steel hoses from the water pump and to the thermostat housing ok (not blocked/rusted) is the heater tap actually operating, you should see the lever from the vacum diaphram move.
|
|||
| Top | |
|||
| kbromage |
|
||
|
joolz wrote: are the steel hoses from the water pump and to the thermostat housing ok (not blocked/rusted) is the heater tap actually operating, you should see the lever from the vacum diaphram move. yes i did all of the above.i've resigned myself to the fact that the plastic arm on the servo moter is broken.the servo is moving but the door obviously isn't.thanks for your help.i'm going to pull the dash out and take a look.
|
||
| Top | |
||
| kbromage |
|
||
|
kbromage wrote: joolz wrote: are the steel hoses from the water pump and to the thermostat housing ok (not blocked/rusted) is the heater tap actually operating, you should see the lever from the vacum diaphram move. yes i did all of the above.i've resigned myself to the fact that the plastic arm on the servo moter is broken.the servo is moving but the door obviously isn't.thanks for your help.i'm going to pull the dash out and take a look. |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 28 guests |
