|
| Froudey |
|
||
|
any one got directions on how to remove the stock EA bar, i it has slipped down a bit and seems to wired up with tye wire. and yeah any one got directions on how to remove it.
caus i want to remove it and clean the bar maybe paint it again and put it on proply.
_________________ R.I.P Tobias my son. |
||
| Top | |
||
| Bob Hall |
|
||
|
Basically, it's bolted on to the end of the chassis rail. You might have to disconnect your horn wiring before it comes off completely, but once you've undone the bolts, it should slide forward. However, if someone's bodgied it up with tie wire, you might have to snip it!
_________________ Commercial Sponsor
|
||
| Top | |
||
| Froudey |
|
||
|
cheers i will try that tomorrow to late now f**k COLD out here!! so a few bolts and yeah
_________________ R.I.P Tobias my son. |
||
| Top | |
||
| Leroy |
|
||
|
basically a few bolts yes. you hsould probably replace the slides that clip into the guards. that is probably why it has slipped down. they are plastic and tend to lose shape after 15 years
_________________ Now driving a Hilux |
||
| Top | |
||
| MARK.TANIA |
|
||
|
hay froudey'' come and stay in orange for a while '' it is nearly sleating here it is a lot warmer in dubbo than orange . are you going to the bathurst cruise?
|
||
| Top | |
||
| twirqurky |
|
||
|
Well well its a cold 7deg up here.
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 18 guests |
[/url]