Just wanted to find out if anyone knows of the procedure in replacing outer weather strips on EF / EL's. The rear door external rubber window seal is damaged and i need to replace it.
Anyone know how to do this without much fuss?
Thanks.

If you are talking about the belt mould that runs horizontal along the top of the door they are held on by a phillips head screw at one end then lift and slide forward{front one slide back}
If you are talking about the window rubber {baily channel}remove the belt mould and the door trim wind the window down pull the top of the rubber down then slide the sides out to replace slot rubber in the metal groove put some graffite powder on the furry bit that the glass rubs on and slide down into place make sure the glass sits in the right spot.If it gets tight towards the bottom wind the window up a little then as you wind down push the rubber with it