Fordmods Logo

ED Instrument cluster - trouble with temp guage 

 

Page 1 of 1 [ 1 post ] 

 
 Post subject: ED Instrument cluster - trouble with temp guage
Posted: Sat Jun 07, 2008 2:04 pm 
Oompa Loompa
Offline

Posts: 31

Joined: 18th May 2008

Ride: ED2

Location: Sydney
NSW, Australia

Just replaced my ED low-series cluster to a mid series (sports) cluster. With the old cluster the temp guage didn't work...and same with the new cluster too. Knew I'd have to change the sender anyway, so I did (tried 2 different senders I took out of futuras at the wreckers )...still no go ...suspect it may be a wiring continuity issue. Have read the doc about changing clusters and noted the appliccable connector & wire on the cluster. HOW TO CHECK CONTINUITY ALONG THE SENDER WIRING?? or is there something I can rig up to the engine-end of the sender-wire to check if there's any signal getting through to the guage?? Could it just be that all 3 senders tested (or both guages) just happen to be buggered??? Any input would be appreciated muchly! thanks guys.
Top
 Profile  
 
Display posts from previous:
Sort by  
 Page 1 of 1  [ 1 post ] 

Who is online

Users browsing this forum: No registered users and 18 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

 

 

It is currently Sat Dec 16, 2017 10:57 am All times are UTC + 11 hours

 

 

(c)2014 Total Web Solutions Australia - Australian Web Hosting and Domain Names