i carnt figure out how to put picks on cause im chalanged when it cones to computers

when u click on post reply go to add attachments then find the pic and your done

If you can find a decent gearbox, go for it:

You have a few parts on top of that. You can use your ECU to suit the manual, no problems.

Interior:
- Pedal Box (You can get an adapter to hook up to your auto pedal box, from Mal Wood)
- Center Console
- Gear Boot
- Gear Knob

Mechanical:
- Gearbox
- Starter Motor
- Bell Housing
- Crossmember
- etc

Tailshaft: Need to get a yoke to suit the Manual

Electrical: All good here, just need to re-solder the circuit on your ECU, or find a Manual ECU.

Fitting: Should be about the $500 mark if you pay someone to do it.

If you find a box, before you put it in, if it's been used a lot, rebuild it. If not service it.

Cheers

sound like a plan ill have to look into it more thanks