|
| 1994EDXR6 |
|
||
|
Does anyone know the recomended impco mixer model for a 1994 XR6?
Any help would be appreciated. Cheers |
||
| Top | |
||
| snap0964 |
|
|||
|
For a BBM manifold, Normally a 200 model, as it is a right angle hookup.
I've adapted a 225, but there is a bit of extra ducting needed. For a log manifold, the 225.
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| MRE-50L |
|
|||
|
aggread . the 200 can get a little starved for gas with high accelleration . not good for internals
_________________ Chance Favors The Prepared Mind ! |
|||
| Top | |
|||
| 1994EDXR6 |
|
||
|
Thanks again for the replies.
I called a LPG shop and asked the same question. I was told they don’t give out that information. Out of curiosity could it be a liability issue or, my perception was that they didn’t want to commit to using the rite parts. If I’m spending the dosh, I would like to know what parts are being put on the car. Does this seem unreasonable? |
||
| Top | |
||
| gogetta |
|
|||
|
1994EDXR6 wrote: Thanks again for the replies.
I called a LPG shop and asked the same question. I was told they don’t give out that information. Out of curiosity could it be a liability issue or, my perception was that they didn’t want to commit to using the rite parts. If I’m spending the dosh, I would like to know what parts are being put on the car. Does this seem unreasonable? d***head as usual.....I have searched and asked far and wide in order to find an honest gas installer in the western subs, but no luck I have a 200 mixer on both my falcons (ED and EF)....it does suit the ED well but not very good on the EF.....Ive got gas research ready to go on soon
_________________ Last edited by gogetta on Sat Apr 26, 2008 12:07 pm, edited 1 time in total. |
|||
| Top | |
|||
| splatt |
|
||
|
[quote="1994EDXR6"]Thanks again for the replies.
I called a LPG shop and asked the same question. I was told they don’t give out that information. Don't go near them when you do the installation. |
||
| Top | |
||
| 1994EDXR6 |
|
||
|
Ive been thinking about the BBM intake upgrade, can I use my existing ECU or do I need to upgrade that as well.
I hope Im not being a pain to ask, but does someone have the break down to swap from log to BBM? Thanks in advance snap0964 wrote: For a BBM manifold, Normally a 200 model, as it is a right angle hookup.
|
||
| Top | |
||
| 1994EDXR6 |
|
||
|
|||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 7 guests |
