|
| xr8 dismantler |
|
|||
|
i run one of these on the Sierra at the dyno day
stock EB 5ltr motor with 5 speed extractors & exhaust made 138kw dyno operator says that air/fuels were good Mick also has put one on his DC ltd that his father is driving his father has said he noticed better throttle response |
|||
| Top | |
|||
| Timmeh |
|
||
|
So it does work hey. Thats good. I guess put it on and take it to get a dyno done and the AFRs checked out OK.
Sounds like a good thing to do then. You wouldn't have a picture of the guts of it from the front of it would you? |
||
| Top | |
||
| xr8 dismantler |
|
|||
|
|
|||
| Top | |
|||
| Timmeh |
|
||
|
HAHA funnily enough I was meaning the other side. I would like to see the sample hole for the heating element.
Cheers |
||
| Top | |
||
| xr8 dismantler |
|
|||
|
no more photos at the moment sorry the camera is at work
|
|||
| Top | |
|||
| Timmeh |
|
||
|
No worries. If you can post one up on Monday or Tuesday that'll be great. I'm keen on getting one and will email you when I have made my mind up.
Cheers |
||
| Top | |
||
| Bsjenko |
|
|||
|
So these will fit straight onto earlier series falcon no probs?
Would you have to drill or screw anything new into it at all to fit NL fairlane? cheers BEN
_________________ The Lane Lives.... Finally!!!! |
|||
| Top | |
|||
| Timmeh |
|
||
|
No you dont need to drill anything. You just have to change over the electronic bits. A couple of torx bit screws. Then just straight swap it over and voila! 20mm bigger diameter.
|
||
| Top | |
||
| Bsjenko |
|
|||
|
hmmm.... i shall be in contact with ya darren in the next few days. i must consult the finance department (aka the wench)
_________________ The Lane Lives.... Finally!!!! |
|||
| Top | |
|||
| xr8 dismantler |
|
|||
|
castlegreyskull wrote: hmmm.... i shall be in contact with ya darren in the next few days. i must consult the finance department (aka the wench)
i find its easier to beg forgivness than it is asking permission 
|
|||
| Top | |
|||
| xr8 dismantler |
|
|||
|
down to the last couple now
|
|||
| Top | |
|||
| scottr33gtst |
|
||
|
I WILL TAKE ONE!!!!
put my name down as i cant email you from school! what injecters will i have to use? can i just buy the tube thing for the injectors and it will fit straight in?
_________________ Modified EBII/ED XR8
|
||
| Top | |
||
| xr8 dismantler |
|
|||
|
scottr33gtst wrote: I WILL TAKE ONE!!!!
put my name down as i cant email you from school! what injecters will i have to use? can i just buy the tube thing for the injectors and it will fit straight in? send us a email when you can |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 26 guests |
