All this stuff was used on my car to help me run a best of 10.6@125MPH, is coming off a running car so it's all proven.

Turbo kit:

-Garrett 3540/3582 whatever you wanna call it (off a XR6T)
-Ported rear housing with 38mm flapper
-12 psi actuator
-AIT cast manifold (no cracks)
-3" dump pipe with internal gate plumbed in
-270x600x76mm cooler which can be hidden behind a standard EA-ED front bar
-2.5" hot side piping, 3" cold side (won't come with the hose clamps, but comes with all the joiners)
-Comes with oil/water lines and heat wrap
-3" intake pipe with pod filter

Turbo is in good nick, I replaced it when I built the new motor. Cooler piping was done by me as well, so it's not show quality but it does the job, it's all painted black. Plenum also available at extra cost, cooler piping will suit the plenum, but your shock tower will need to be slightly massaged to make it fit.

After $2650 for the turbo kit, $3100 including plenum.

Located in the Eastern suburbs of Melbourne.










*******************************************************************

Last bumped by needfordspeed on Thu Feb 23, 2012 7:58 pm.