|
| madeaspack |
|
||
|
im just starting (slowly) on a turbo build on the el xr6,gonna re build an engine and all that stuff,my question is...
some of you guys say you can use a chiptorque or similar chip effectively with a low boost turbo application. as i already have a chiptorque chip im wondering how effective it is,like whats low boost??i think i wanna run about 8-9psi would that work with the chip and rising rate reg and bigger injectors??also what size injectors would i need for 9psi of boost? cheers guys
_________________ 97 el xr6,5 speed short shifter,sequential scoop,no arial,freshly resprayed,low on 17's,3 inch zorst,stainless hi flo cat,snort stage 3 stainless manifold,garrett t04e,front mount cooler,wolf 3d ecu,seimens 760cc injectors,walbro fuel pump |
||
| Top | |
||
| schnoods |
|
|||
|
A few blokes are using the capa switch eliminator chip which works ok.
For 9 psi minimum would be 24lbs, but 30 or even better 36 should see it thru.
_________________ Because of Beer, Thirst is a Beautiful Thing! |
|||
| Top | |
|||
| Denim |
|
|||
|
From what I heard and read Chiptorque handles around 5 to 6psi, thats all, Eliminator switch or the Sniper might be the way to go, if finances allow, then you have better ones available..
_________________ Denim (BAXR6) nothin like a couple of Eaton M90's on, to show whos BOSS.... |
|||
| Top | |
|||
| TURBOTAXI |
|
||
|
I use a chiptorque chip on my turbo AU.
Doesnt detonate now. Not ideal as not boost referenced.
_________________ Turbo AU falcon LPG 222.5 RWKW. |
||
| Top | |
||
| madeaspack |
|
||
|
thanks guys,i'll sell the chip and get wolf 3d or somethin
_________________ 97 el xr6,5 speed short shifter,sequential scoop,no arial,freshly resprayed,low on 17's,3 inch zorst,stainless hi flo cat,snort stage 3 stainless manifold,garrett t04e,front mount cooler,wolf 3d ecu,seimens 760cc injectors,walbro fuel pump |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 15 guests |
