|
| blinkAU |
|
||
|
Hi guys this is the current setup under my bonnet at the moment
The current bov sounds s**t, I was wondering do you think I could fit a hks sqv bov into that area? http://cgi.ebay.com.au/New-SSQV-Blow-Of ... dZViewItem Is the one im looking on ebay but I am unsure if I can use it. Any help would be great |
||
| Top | |
||
| Molloy |
|
|||
|
if its universal then yeah, thats the same one my slaaaabs running.
_________________ SS Inductions CAI, K&N Filters, M-spec FMC, Turbosmart BOV, 8psi capa tune, X-force cat. |
|||
| Top | |
|||
| blinkAU |
|
||
|
Thanks for the quick response Molloy.
I think I could get it to fit since its universal but its the spacing issue im concerned about. With the hks one the mounting point appears to be on the side of the bov rather then on the top/bottom like the current bov I have. Im just wondering do you think its possible to make it fit into that space? |
||
| Top | |
||
| Molloy |
|
|||
|
yeah there not normally much bigger then the one you have now, well the ones ive seen.
_________________ SS Inductions CAI, K&N Filters, M-spec FMC, Turbosmart BOV, 8psi capa tune, X-force cat. |
|||
| Top | |
|||
| fordman351 |
|
|||
|
My mate has one on his S13 CA18 Silvia, and it is bloody huge, not to mention annoying haha
 . But i reckon you might 'just' squeeze it in there. I'll try and post up some pictures and measurements tomorrow for ya. I'll even try to get a soundclip for you too  .
EDIT: That BOV in that link is a HKS 'lookalike' the genuine ones are about $550! 
|
|||
| Top | |
|||
| glenneaux |
|
||
|
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 7 guests |
