|
| Nicknz |
|
||
|
5.0 GT40 y303 heads have a bigger exhaust port is there a gasget to fit these ports if so can some one give Me a part number
|
||
| Top | |
||
| XR9UTE |
|
||
|
G'day Nick,
You'll find that just about any exhaust gasket will fit because they are usually a fair bit bigger than the actual stock exhaust port opening. I used a stock Felpro header gasket on my Y303 heads which, you'll see I used in the "351W into XE" post at the top of the V8 Forum. The expanded metal gaskets that most exhaust shops have are large enough for just about any std bolt pattern windsor exhaust too. Pete. |
||
| Top | |
||
| Nicknz |
|
||
|
Hi Pete, I,am trying to match port the heads to exhaust pipes and are finding there isn't enough of the gasget left on the botton edge and they burn through
|
||
| Top | |
||
| TerroristGHIA |
|
|||
|
Felpro do a large exhaust gasket, i dont have the part no, but when i put the difillipo's on mine, the stock gaskets shrouded about a third of the port. The Felpro one fixed this.
Brett
_________________ The Terrorist ED Retired due to RUST. |
|||
| Top | |
|||
| sooty72 |
|
|||
|
From the Felpro book -
Standard exh header gasket - port size - 1.05" x 1.35" - p/n 1467. Small race exh header gasket - port size - 1.25" x 1.48" - p/n 1415. Hope that helps. 
_________________ Yes, I own a Ute. No, I won't help you move! |
|||
| Top | |
|||
| eboost |
|
|||
|
the y303's are an aluminum gt40p. Pretty much same casting and marginally better flow. Well that's what i came to when researching them as a possibility for my engine.
|
|||
| Top | |
|||
| Sturmovik |
|
|||
|
Not the same casting, for starters they dont have the stupid plug angle of the GT40p
_________________ 1993 ED XR6 5speed Polynesian Green. Project car. |
|||
| Top | |
|||
| eboost |
|
|||
|
Sturmovik wrote: Not the same casting, for starters they dont have the stupid plug angle of the GT40p sorry, they must be gt40 castings |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 17 guests |
