|
| Bsjenko |
|
|||||
|
in the shed playing with motor, and have never taken out a cam before.
how do you remove it? i have aken the keeper plate off, and it prob moves about 20mm by itself. Do i just have to yank at it to get it too come out, or is there a trick? this is what i have at the moment. (pic) cheers BEN
_________________ The Lane Lives.... Finally!!!! |
|||||
| Top | |
|||||
| Krytox |
|
|||
|
have you removed the rods/lifters out?
_________________ Carefree, we may not be number one, but we're up there. |
|||
| Top | |
|||
| Bsjenko |
|
|||
|
yes sir.
_________________ The Lane Lives.... Finally!!!! |
|||
| Top | |
|||
| hans hartman |
|
||
|
castlegreyskull wrote: yes sir. is the front of the cam threaded in the centre hole,if so -use it to turn and ease the cam out---carefully not to damage cam bearings.
_________________ R.I.P HANS HARTMAN |
||
| Top | |
||
| DSTRBD |
|
|||
|
i have tried once and fluked it...
i used the handle off my angle grinder. I unscrewed it from the angle grinder and just my luck, it screwed in where the cam bolt normally goes and i slowly pulled it out that way. if you try it, who know's, you might get lucky too or you can take the same principle and fabricate your own way.
_________________ NO TV AND NO BEER MAKE HOMER GO SOMETHING SOMETHING... |
|||
| Top | |
|||
| Bsjenko |
|
|||
|
Cheers fellas, its out. Bit of jiggleing and it came, just wasnt sure how easy it came out, didnt wanna root anything.
Cheers
_________________ The Lane Lives.... Finally!!!! |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 22 guests |
