This document describes the pinouts, and wiring for the EEC-IV Engine Control Module, for the EB 8 cylinder Model Ford Falcon, Futura, Fairmont, Fairmont Ghia, Fairlane, LTD, and XR8 model Falcons.
The information includes wiring connector pin-outs, wire colours, expected voltages, and wire feature.
Wiring Connector Pin outs
The above image describes the EEC-IV module Pin numbers, that are used on the Engine Control module.
The EEC-IV Module is located behind the Left Hand Side Kick Panel, On the passenger side of the vehicle, near the front seat.
To remove the kick panel, and gain access to the EEC-IV module, you will need to complete the following.
1 Remove the 3 Retaining screws on the plastic door scuff plate, and remove the scuff plate.
2 Remove the plastic plugs used to secure the plastic kick panel.
3 Pull the back of the kick panel towards the transmission, to disengage the kick panel from the chassis.
4 Finally slide the kick panel backwards towards the back of the car.
The EB EEC-IV Wiring connector is the Standard Ford 60 Pin Connector, as used on the XF 4.1 EFI, EBII 4.0, and ED 4.0 EEC modules.
Please Note that Pin 1. Is located on the lower Row, Far Left, when the wiring connector is facing somewhere pretty.
EEC-IV Wiring Information
Pin No
Wire Colour
Purpose
Voltage
1
Keep Alive Power
Battery +12V
2
Not used
3
Not Used
4
Not Used
5
Auto Transmission Reverse Signal and Tacho
Engine running Trans in Reverse 900RPM, Trans in Gear 450Rpm
