 |
|
|
|
|
|
|
|
|
|
blue
Fordmods - Smokin em up
Posts: 247
Joined: 11 Sep 2005
Location: Werribee VIC, Australia
View User Gallery (0)
|
 Posted: Sat Jul 26, 2008 9:22 pm Post subject: Pulling out a Blend motor anything i need to know? |
 |
|
| I'm goin to the wreckers tomorrow to get a blend motor for my EL. I was wondering if there is anything i need to know, I know how to get to it and what it looks like(thanx to Krytox). Just was wondering if i need to take note of the position its in when I pull it out or if there is a way to test it? |
|
| Back to top |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Krytox
Technical Contributor
Age:29
Posts: 2506
Joined: 20 Mar 2005
Location: Seaford State: VIC, Australia
View User Gallery (2)
|
| Posted: Sun Jul 27, 2008 1:06 am Post subject: |
|
|
Take a cordless drill with a long sharp drill bit. (around 5mm)
Yes you can butcher the motor off and pull the rivets through the heaterbox, but you'll bend the bracket,
Pop the 2 easy rivets and spin it round a bit.
The plastic crank pops out with a flat screwdriver.
also removal of the dash, take a LONG 3/8 extension bar with a 10mm socket on it. theres 4 main bolts knee high (2 either side and 2 center) when all screws, bolts, earth straps, wires etc are removed, LIFT the dash 2-3cm and pull it out. |
|
| Back to top |
|
|
|
|
|
|
|
|
|
twason
Fordmods - Getting Side Ways
Posts: 2017
Joined: 06 Nov 2004
Location: Canberra - The Nations Capital ACT, Australia
View User Gallery (9)
|
| Posted: Sun Jul 27, 2008 7:58 am Post subject: |
|
|
| Also remember they are not that expensive from Ford at around $70. |
|
| Back to top |
|
|
|
|
|
|
|
|
|
blue
Fordmods - Smokin em up
Posts: 247
Joined: 11 Sep 2005
Location: Werribee VIC, Australia
View User Gallery (0)
|
| Posted: Sun Jul 27, 2008 11:11 am Post subject: |
|
|
| thanx for the help |
|
| Back to top |
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
