 |
|
|
|
|
|
|
|
|
|
alfy12
Fordmods Newbie
Age:41
Posts: 13
Joined: 21 Aug 2008
Location: wagga NSW, Australia
View User Gallery (0)
|
 Posted: Sat Aug 23, 2008 5:23 pm Post subject: NF Fairlane no demister funtion so can't program smartlock |
 |
|
| Hi all. Just purchased a new smartlock remote from ford dealer and went to carry out the programming procedure in the owners manual. Only problem is no rear demister function so can't program remote. I have checked the fuse, switch and both ok. Light on dash wont illuminate when rear demister switch pushed. Could it be an open circuit rear demister? Any help appreciated. Car is a 06/1995 NF Fairlane. |
|
| Back to top |
|
|
|
|
|
|
|
|
|
revhead
Fordmods - Getting Side Ways
Age:40
Posts: 672
Joined: 05 Nov 2005
Location: oberon NSW, Australia
View User Gallery (0)
|
| Posted: Sat Aug 23, 2008 5:35 pm Post subject: |
|
|
| Check the conections and see that there are no breaks in the demister itself also welcome to the site |
|
| Back to top |
|
|
|
|
|
|
|
|
|
twason
Fordmods - Getting Side Ways
Posts: 2092
Joined: 06 Nov 2004
Location: Canberra - The Nations Capital ACT, Australia
View User Gallery (9)
|
| Posted: Sat Aug 23, 2008 5:48 pm Post subject: |
|
|
| Also check that the demister lead is plugged into the correct switch, the antenna height and the demister can be swapped around accidentially. |
|
| Back to top |
|
|
|
|
|
|
|
|
|
alfy12
Fordmods Newbie
Age:41
Posts: 13
Joined: 21 Aug 2008
Location: wagga NSW, Australia
View User Gallery (0)
|
| Posted: Sat Aug 23, 2008 7:36 pm Post subject: Thanks for the quick response |
|
|
I had the dash out today to clean the climate control keypad. Had to disconnect the antenna switch and demister switch to remove shroud. They both seemed to be in the correct coloured sockets. Would anyone have a wiring diagram of this circuit. I still have to get a workshop manual.
Great to be part of this forum. Cheers.
 |
|
| Back to top |
|
|
|
|
|
|
|
|
|
alfy12
Fordmods Newbie
Age:41
Posts: 13
Joined: 21 Aug 2008
Location: wagga NSW, Australia
View User Gallery (0)
|
| Posted: Sun Aug 24, 2008 10:13 am Post subject: Plugs in wrong sockets |
|
|
Thanks twason. Pulled the dash shroud forward this morning and noticed both switches are black and have the same receptacle. The blue plug was at the bottom and the white plug at the top. As soon as I disconnected both I looked at the pin locations and noticed one plug has one pin offset. I looked for the same pinout on the switch and noticed the two were around the wrong way. Plugged them in correctly and programmed smartlock. The blue plug should be at the top (antenna height switch) and the white plug at the bottom (rear demist).
Thanks again guys for the quick response.
 |
|
| Back to top |
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
