|
| EBmate |
|
|||
|
hey i tried lookin but i couldnt find anything sayin you can make a shiftkit with a switch for an eb the only ones mention in other discussions are the shiftkits without the switch... im just being precautious an askin do i just incorporate the switch designs from the el/ef version but use 20ohm and 1.0ohm resistor and the EB pin57 an 38
i tried lookin an there werent any direct comments for making these so i was just presuming i would hav to just switch resistors an pin numbers in the diagram to suit my eb.. cheers
_________________ at the bottom of the chain |
|||
| Top | |
|||
| 4.9 EF Futura |
|
|||
|
Pretty much mate...
Use the switched diagram but use the pin numbers and resistor values for your car... Just have a good look at the diagram... draw it out on a bit of paper - it'll make sense....
_________________ I promise..... I will never die. |
|||
| Top | |
|||
| Disco Frank |
|
|||
|
i can make u a kit for your car with a switch no dramas!
_________________ RIP SCOTT |
|||
| Top | |
|||
| EBmate |
|
|||
|
nah its alrite thanks anyway man, i was just curious didnt wanna do anythin without being sure of it!
_________________ at the bottom of the chain |
|||
| Top | |
|||
| Heeno |
|
|||
|
i tryed wiring mine up, and couldn't find pin 38, so i cut pin 40, is this right? the car still works but i don't think the shift kit does? has anyone done this before and what pin numbers did you use?
cheers
_________________ Cars: EB Fairmont 5spd 3.9L**sold**
|
|||
| Top | |
|||
| Disco Frank |
|
|||
|
mmm no u need pin 38
have a look with a torch to see the pin numbers do u have a EB s1 or s2? as u may have the seperate trans ecu
_________________ RIP SCOTT |
|||
| Top | |
|||
| Heeno |
|
|||
|
yea its a series 1 3.9L
_________________ Cars: EB Fairmont 5spd 3.9L**sold**
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 55 guests |
