|
| mystro |
|
||
|
will i f@ck all my new stuff,if i do up the front disc nut by hand ?
and dont do up the disc to 15nm and undo 1/2 turn. my brakes have seriously gone to shight and my tourqe wrench is in hock till next week  also i bought new ball joints and had them pressed into spare spindles. the lower joints (powermax) dont have grease nipples .. all the joints are very stiff and wondering is this from lack of grease? the old ones move freely. how do i and do i need to get grease in there ? much apreciated CHEERS PAUL |
||
| Top | |
||
| GASSA |
|
||
|
Mate
I have never used a torque wrench to tighten wheel bearing 1 Tighten up the wheel bearing 2 back off nut 90 degrees 3 tighten nut till nut contacts washer 4 check for looseness 5 install spilt pin done If ball joint has no grease nipple then it is sealed for life. gassa
_________________ When the clutch drops the bull s**t stops!!!!! |
||
| Top | |
||
| cczfairmont |
|
||
|
mystro wrote: will i f@ck all my new stuff,if i do up the front disc nut by hand ? and dont do up the disc to 15nm and undo 1/2 turn. my brakes have seriously gone to shight and my tourqe wrench is in hock till next week also i bought new ball joints and had them pressed into spare spindles. the lower joints (powermax) dont have grease nipples .. all the joints are very stiff and wondering is this from lack of grease? the old ones move freely. how do i and do i need to get grease in there ? much apreciated CHEERS PAUL do you mean the caliper nut? if it's the caliper nut i normally use an adjustable wrench plus a ratchet. does the job fine and my opinion, better than a tq wrench cheers |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 31 guests |