|
| twr7cx |
|
|||
|
How much wobble should the drive shaft that comes through the extension (that turns the tailshaft) housing of the BTR 4 speed have? Mines fairly wobbly, wondering if that's the reason why the seal was leaking?
|
|||
| Top | |
|||
| Slick |
|
|||
|
it shouldn't wobble, just a bit of end play.
_________________ Mind f**k!!! it works on feeble minded ignorant sheeples... there's plenty of em on this site... some are very intelligent but by god they are so thick!!! Pakrat wrote: You can buy them seppertly
|
|||
| Top | |
|||
| stockstandard |
|
|||
|
cant say ive ever seen one that didnt move a few mm each way
_________________ Stoke me a clipper, I'll be back for Christmas |
|||
| Top | |
|||
| just me |
|
||
|
the shaft is wobbly because of the bush in the back of the trans is worn out thats why ur seal leaked u can get the bush replace at a trans shop or get a bush and do it urself not that difficult
|
||
| Top | |
||
| joolz |
|
|||
|
Well done just said! as stated the extension housing bush has worn thus causing the seal to go, this could also cause imbalance of the driveshaft.
|
|||
| Top | |
|||
| twr7cx |
|
|||
|
i looked in the repair bookie thing and couldn't find any mention of a bush, which suprised me. anyways i'll find out, ta.
|
|||
| Top | |
|||
| joolz |
|
|||
|
It wont as the bush is behind the extension housing seal, the rear of the trans has to be removed to change this bush.
|
|||
| Top | |
|||
| twase |
|
|||
|
just me wrote: the shaft is wobbly because of the bush in the back of the trans is worn out thats why ur seal leaked u can get the bush replace at a trans shop or get a bush and do it urself not that difficult Talk to a transmission specialist, there is two types of bushes, one will not wear as quick, mine cost about $70 inc new seal to get it replaced, I was told it requires a special tool to remove in the car.
_________________ BF Fairmont Ghia Series II update. |
|||
| Top | |
|||
| joolz |
|
|||
|
Yeah the special tool is a hydraulic press! however its spelt !
|
|||
| Top | |
|||
| twase |
|
|||
|
joolz wrote: Yeah the special tool is a hydraulic press! however its spelt ! Not exactly, it is a special puller to do it while on the car rather than removing the extension housing.
_________________ BF Fairmont Ghia Series II update. |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 20 guests |
