Fordmods Logo

XH into XG removing old engine but leaving trans in place 

 

Page 1 of 1 [ 1 post ] 

 
 Post subject: XH into XG removing old engine but leaving trans in place
Posted: Wed Jun 28, 2017 12:00 pm 
Fordmods Newbie
Offline

Age: 51

Posts: 6

Joined: 3rd Feb 2017

Ride: XG Longreach

Location: Melbourne
VIC, Australia

Hi, ready to remove EB motor from ute and replace with XH motor. Have removed bolts from engine mounts, bell housing,fan,radiator,battery, air box, exhaust, heater hoses etc and loom. There is a thin metal plate covering the where the torque converter is,between the trans and the rear of the motor. I am not sure what to do next as I've read about undoing torque converter to flex plate or flywheel bolts and sliding torque converter over drive shaft from the trans, before hoisting motor out. Do I need to remove this plate to get to these bolts, or is it the full diameter of the bell housing making removal difficult as the drive shaft goes through it? I've read about a sandwich plate, is this the thin metal plate that basically stops crap getting to the flywheel, that covers the lower half of the bell housing?
Any help would be appreciated, thanks.
Top
 Profile  
 
Display posts from previous:
Sort by  
 Page 1 of 1  [ 1 post ] 

Who is online

Users browsing this forum: No registered users and 24 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

 

 

It is currently Sun Oct 22, 2017 8:32 am All times are UTC + 11 hours

 

 

(c)2014 Total Web Solutions Australia - Australian Web Hosting and Domain Names