|
| alfy |
|
|||
|
I have them, but at the moment my internet is capped and the uploads will take way way way way too long, photobucket wont even load up properly. I'll get them up eventually lol
_________________ 2021 V6 Manual Amarok - 245kw/750nm - many goodies |
|||
| Top | |
|||
| snap0964 |
|
|||
|
Yeah, bit of a shame it hasn't seen some undercover time during it's life up to now.
Pull the trims off around the glass - most likely find some rubbish/dirt around the urethane gluing, gets wet and can be a nice rust starter, because the trims hold it in. The lower weatherstrips on the rear qtr fixed glass will need to come off - the clips don't seal real good over time - water gets in, particularly the front holes. Water then runs down the rear wheelarch, soaks in well with the soundproofing, no holes to drain. Externally, you'll see bubble rust in the doglegs in front of the rear wheels. You can make up rubber washers to fit over those clips, so they seal when clipped in. Same deal with the C pillar body coloured fascia's too.
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| alfy |
|
|||
|
yeah my top windscreen aperture has a small amount of rust at the moment, but i simply cant afford to do anything about it until i get a job thats better than s**t, which in this place will probably be never.
regarding the rear 1/4 belt moulds, i believe the clips are NLA from Ford, and they break pretty easy so i might have to work my way around it... or break the clips off and urethane the mould on 
_________________ 2021 V6 Manual Amarok - 245kw/750nm - many goodies |
|||
| Top | |
|||
| snap0964 |
|
|||
|
If you take the inside panel out, you can get to most of them and squeeze them to 'pop' them.
Front one you'll have to carefully lever out - put a bit of cloth tape on the panel to help protect it. Be careful with these, as you can bow the moulds - they can be hard to straighten if you bend them too much.
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| alfy |
|
|||
|
snap0964 wrote: If you take the inside panel out, you can get to most of them and squeeze them to 'pop' them. Front one you'll have to carefully lever out - put a bit of cloth tape on the panel to help protect it. Be careful with these, as you can bow the moulds - they can be hard to straighten if you bend them too much. hehehe, ive broken plenty in my time at work ford ones are easy compared to some toyota/hyundai ones.
_________________ 2021 V6 Manual Amarok - 245kw/750nm - many goodies |
|||
| Top | |
|||
| alfy |
|
|||
|
been a long time coming but here they are... i did have ones of during the repairs but ive lost them
     (sills are painted in stoneguard at the moment.... need to save up for more paint    
_________________ 2021 V6 Manual Amarok - 245kw/750nm - many goodies |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 17 guests |
