|
JesseGee |
|
||
|
Ok, so I have an one XF auto column shift ute. and a XF sedan with a t5 box in it. Will it be pretty straight forward doing the conversion, I know ill have to change pedal box. Because of the ute being column shift, will its have the hole in the floorpan for the gearstick? and are all bell housings the same? is there anything else i would have to worry about?
Thanks! |
||
Top | |
matt_itchy |
|
|||
|
Gear box should all go straight in. You will have to cut a hole and I think from memory have to fit a hump inside where all the gear shift lever comes through. That's if you are converting to bucket seat. Also if you fit a centre consol there is an extra mount on the floor where the console screws go the floor between the seats. Otherwise if you are staying with a bench seat you probably just have to cut the hole and rig up some sort of boot to cover the shift lever set up. You will need to swap the loom to the gear box and change the computer.
|
|||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 3 guests |