
			
  | 
	
| weeman | 
				
  | 
		||
				
  | 
			
					 
							
							Yeah, probably a good idea.
 
				Was that duty cycle with acceleration enrichment?  | 
		||
| Top |   | 
			||
| viper1431 | 
				
  | 
		||
				
  | 
			
					 
							
							I'm pretty sure the enrichment wasn't a factor anymore  if i understand the settings right.  I floored it from near idle and it took about 9 seconds to reach the 4400rpm so the enrichment should have been over with.						
						
						
												 
				 | 
		||
| Top |   | 
			||
| viper1431 | 
				
  | 
		||
				
  | 
			
					 
							
							Can i just check with yas that for the ignition the brown wire from the TFi is the PIP signal and the yellow/green one is the spout ?
 
				I can't get it to run the ignition.. with just the ignition input wire hooked to the pip line it tries to start and will sometimes idle for 2 or 3 seconds then die... if i hook the spout one up (i've checked im using the right blue.white wire form pin 24) it will do nothing except make a constant clicking noise which i think is coming from the coil.  | 
		||
| Top |   | 
			||
| weeman | 
				
  | 
		||
				
  | 
			
					 
							
							You can leave spout disconnected and the TFI module will default to base timing.
 
				Have you changed the fuel pump relay across to the MS?  | 
		||
| Top |   | 
			||
| MMD | 
				
  | 
		||
				
  | 
			
					 {USERNAME} wrote: Have you changed the fuel pump relay across to the MS? 
This in pin 37 on MS? connects to pin22 on car ?  | 
		||
| Top |   | 
			||
| weeman | 
				
  | 
		||
				
  | 
			
					 
							
							Yes.  The stock ECU won't run the fuel pump if it doesn't get the PIP signal.						
						
						
												 
				 | 
		||
| Top |   | 
			||
| viper1431 | 
				
  | 
		||
				
  | 
			
					 
							
							Ah i see.  I still have the stock ECU running the fuel pump so looks like i will have to go change that over.						
						
						
												 
				 | 
		||
| Top |   | 
			||
| jasonk | 
				
  | 
		||
				
  | 
			
					 
							
							Hi viper
 
				just curious is your car manual or auto? i am looking at building a megasquirt real soon , i just finished building my jim stim  | 
		||
| Top |   | 
			||
| viper1431 | 
				
  | 
		||
				
  | 
			
					 
							
							Its a manual.
 
				Everything is running quite nicely now, fuel and spark. Although without a dyno around here tuning the spark can be a pain as there isn't a real figure to aim for like there is with fuel mix. I think i'm pinging a bit in the mid range full throttle area.  | 
		||
| Top |   | 
			||
| Who is online | 
|---|
Users browsing this forum: No registered users and 14 guests  |