|
| Felony |
|
|||
|
with the serpentine setups on 4.0litres is it possible to remove all that and fit the ea pulleys, balancer, and water pump, power steer and a/c etc? could be getting a ef xr6 motor to put in, and what about coil packs then going to a single coil?
thanks
_________________ Succesful trades with bentles_eb, Pane, chunkz, xr8_dismantler, OBS35N, mrnasty, Steady ED, voxace, Mash85, ovo616, ef biff, lukey, dazza2924, Seannyb, gunit18, jkk, Tocchi, |
|||
| Top | |
|||
| justfordima |
|
|||
|
if you're referring to the EF 4 litre, then yes, the serpentine can be changed. The accessories are the same, with different pulleys. Shouldn't be a problem.
With the EF coil packs, it would be easier to stick in your dizzy, and use that. esepcially electronics wise. Cheers
_________________ ;++JustForDimSim++;
|
|||
| Top | |
|||
| altedxr6 |
|
|||
|
You must also change the timing cover case.
|
|||
| Top | |
|||
| justfordima |
|
|||
|
{USERNAME} wrote: You must also change the timing cover case.
interesting, care to expand? Cheers
_________________ ;++JustForDimSim++;
|
|||
| Top | |
|||
| altedxr6 |
|
|||
|
{USERNAME} wrote: {USERNAME} wrote: You must also change the timing cover case. interesting, care to expand? Cheers Timing marks on the EF/EL are in a different place, and also, about 1/4 of the size of the EA-ED ones. EA-ED has two prongs, one for TDC and one for IGN . The EF/EL has one mark, and its about 2mm big, where the EA-ED ones are about 10mm in size. I changed a Hybrid EL motor to the 3 Belt series, Thats how I found out ... and Done the serp belt conversions before ... same problem .. Change the case while the motor is out 
|
|||
| Top | |
|||
| justfordima |
|
|||
|
cool thanks... cos the timing cover I got for my other engine, was off an EF, meaning serpentine belts for me... he he.
Cheers
_________________ ;++JustForDimSim++;
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 109 guests |
