|
Spork |
|
|||
|
Hey.
I have been looking into cam and chip packages recently. Anyway chip torque have a package with crow cams combining a CROW 2222549 (1100-4400 RPM) cam and HP4 chiptorque chip. All parts required delivered to my door for $1080 Attached is the dyno graphs they sent me. Now IGNORE the absolute ratings becasuse I don't want this to turn into a dyno power figure debate. But does this look like a good option for my EL manual with intake and exhaust mods. I know an aftermarket ecu on the dyno might get better results but it will cost at least 3 or 4 times as much before I will get the driveability I want out of it. They said if I do a dyno run and record the A/F ratio's then they can re-tune for $100 a pop to try and get it better. What are ppl's opinions on these chip's ,experiences etc. Does anyone have this package???
_________________ Manual EL Gli.
|
|||
Top | |
SVO XR6 |
|
|||
|
not too bad if you dont want to go too much further and your happy with it
i had that exact package, and it was good. Untill i upgraded stuff, now i have a stand alone programable ecu moral of the story, good if your goin to keep it that way and spemd a little extra on the tuning ![]()
_________________ |
|||
Top | |
EFfalconsrule |
|
||
|
Yeah sounds good. I might look into one of them.
_________________ Stage 1 stereo install done. Pics in audio section. |
||
Top | |
Spork |
|
|||
|
{USERNAME} wrote: not too bad if you dont want to go too much further and your happy with it
i had that exact package, and it was good. Untill i upgraded stuff, now i have a stand alone programable ecu moral of the story, good if your goin to keep it that way and spemd a little extra on the tuning ![]() How would you describe the difference from standard. More power everywhere? or were there some idle and drivability issues? Did you have to get it re-tuned and what was the difference? Did you get it dynoed and do you have a graph you can post up? Thanks. I don't think I will be going much further in mods than this.
_________________ Manual EL Gli.
|
|||
Top | |
fuzion |
|
||
|
You know a lot of xr6's and other stock engines pulled that+higher reading with or without cams on the syd dyno
plus thats a dyno-s**t dynamix. not exactly overwhelming results from my view sorry! |
||
Top | |
Spork |
|
|||
|
Like I said, ignore the absolute ratings, I think dyno discrepancies have been argued enough.
But relative 96-124Kw is a good 30% improvement. While it doesn't seam to have as much mid-range as an XR6 it's still got more mid than a stock car.
_________________ Manual EL Gli.
|
|||
Top | |
opto |
|
|||
|
Go Unichip (more versatile) and Wade 1636 (torque plus for auto)
![]()
_________________ I post here cos the russian tank driver doesn't |
|||
Top | |
SVO XR6 |
|
|||
|
i never ran the cam without the chip, so wouldnt know
but all it would do is richen/lean AFR's. basicaly you would be silly to cam a car without adjusting fuel/spark maps, waste of time
_________________ |
|||
Top | |
opto |
|
|||
|
I type of got that feeling after getting it done.
Wade 1604 you could get away with but I found the gain really small.
_________________ I post here cos the russian tank driver doesn't |
|||
Top | |
Spork |
|
|||
|
That unichip/wade combo looks like a smaller gain overall.
How much was it? Doesn't a unichip just modify the input sensor signals? Or does it directly control injection/spark. How much for first dyno tune? SVO XR6 - Can you tell me how the car actually drove with the cam and chip combo?
_________________ Manual EL Gli.
|
|||
Top | |
SVO XR6 |
|
|||
|
like any cammed car
thirsty, noting below 2000rpm ![]()
_________________ |
|||
Top | |
Who is online |
---|
Users browsing this forum: Google Adsense [Bot] and 0 guests |