aii guyz, i put a new set of injectors in from my friends EDXR6, hooked everything back up, car started not a problem, waited a bit, turned it off all good, then i went to move it 15 minutes later, n it stalls
tried again, stalls

keeps stalling, have to hold the revs up even then wen i let go it stalls, then after holsding the revs up for a bit, it idles fine, kool, turn it off, turn it back on, stalls, took it for a drive, all good, come home turn it off, start up again, nearyl stalls, but idles fine after nearly stalling, , really peeing me off, the first time we started it , we had it started for awhile n it was fineeee perfect nothing wrong, the engine wasnt tampred with in the mean time wen it was left off, wot could it be?

POS


- Grechie

when you said new set of injectors are tehy new, what kind of car are they out of what are teh specs on em etc

was out of a edxr6, there clean n in perfect condition, nothign wrong with em, infact, my old injectors compared to em were rubbish, complete rubbish

Check the fuel pressure regulator.

You havent pulled the vaccum line off the fuel reg and not noticed?

Or the map sensor vaccum line may have partially come off.

I assume it drives alright once it gets going though?

ill check the fuel pressure regulator, arm79 i checked and no vacuum lines are off, onc edriven round n warmed up she doesnt stall on idle....

I don't know if the ECU autolearns cold start enrichments, but if the old injectors are as bad as you indicate they were, then the ECU will have to re-learn all the fuel tables.

A warm engine will idle on a far wider range of AFRs than a cold engine will. This may be your problem.

could the injectors just be dirty?

You have a leaky o ring