|
| Smackdown |
|
|||
|
{USERNAME} wrote: The dev3hl won't need a new computer. But to get the absolute most out of it, it'd probably be wise.
The Crow Cam 2222549 is a Stage 3 cam, so idling may be way off. No its actually a stage 2 cam mate, the stage 3 is the one above is the 2222543 which actually needs a chip to run. I put that in mine and the idle was all over the place and I had to get the chiptorque chip for it, also to sort out A/F troubles. As for actually answering the question that was asked, the stage 2 crow cam which you are asking about is a good mild cam that will run in your auto although you will rarely stall at the lights during idle while in drive. Other than that its a good value for money billet cam. Hope that helps.
_________________ BA Falcon Futura on EGas. Stock as...
|
|||
| Top | |
|||
| BigBlu |
|
||
|
my car runs fine with the crow stage 3. I had to get better valve springs but im not running antoher computer.
_________________ There is no substitue for cubic inches! |
||
| Top | |
||
| LG |
|
|||
|
Opps my bad, i remembered reading somewhere, that someone had that one, and they said it was a stage 3.
_________________
|
|||
| Top | |
|||
| Smackdown |
|
|||
|
{USERNAME} wrote: Opps my bad, i remembered reading somewhere, that someone had that one, and they said it was a stage 3.
Well, i think they're wrong. Cause its lift and duration is very similar to the EF one.
_________________ BA Falcon Futura on EGas. Stock as...
|
|||
| Top | |
|||
| crumz |
|
||
|
You guys talk of a dev 3 and dev 3 HL cam... what brand/make/profile are you refering to?
I'm looking at a new cam myself (EF Futura - 5Spd - LSD - Dumped - Genie Custom Extractors -> 2.5") I'm not looking for a 'hot hot' cam ... but something that'll give me power/torque from 2000/2200RPM - I'll be upgrading to a new computer shortly after the cam... (I'm hoping it'll be lumpy enough to stall during idle so that i can convince the wife to get a new Chip ASAP  )
Suggestions??? Ta |
||
| Top | |
||
| jonbays |
|
||
|
Get the Dev3HL from Jim mock motorsport or neil101 whose car i have seen run on the dyno and it was impressive.
have a look here at JMM site for info http://www.jimmockmotorsport.com/ |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: Facebook [Bot] and 43 guests |
